진공 송풍기
Home » Vacuum Suction Components » Vacuum Generators » Vacuum Blower
Industrial Vacuum Blowers for Material Handling
Industrial vacuum blowers supply airflow for vacuum handling systems, including applications where porous workpieces allow air to enter continuously. Selection depends on the vacuum needed at the gripping surface and the airflow required to compensate for leakage through the workpiece, seals and connecting lines.
Use the product information below to assess your handling requirements. For a broader comparison of vacuum sources, see vacuum ejectors, pumps and blowers.
Selecting Single-Stage and Two-Stage Vacuum Blowers
A blower must deliver sufficient airflow at the required operating vacuum. Compare the manufacturer's performance curves at that operating point, rather than selecting from maximum airflow or maximum vacuum alone. Pipework, filters and valves also affect the vacuum available at the gripping surface.
For porous wood boards or surfaces with leakage, evaluate the complete gripping arrangement with representative workpieces. A two-stage configuration may increase the available pressure difference within a product family, but its suitability depends on the model, airflow demand and operating limits. Confirm the electrical supply, duty requirements, cooling conditions and required protective devices before selection.



Product Features and Specifications
- Single-stage model vacuum blower
- Medium final vacuum with high flow rate
- Very low vibration
- Long service life thanks to lifetime-lubricated bearing
- Available as a complete construction unit with assembled change-over valve, suction limitation and vacuum filter
Maintain the blower according to its manufacturer’s instructions. Keep filters and cooling passages clear, inspect connections and protective devices, and replace service parts as specified. Do not add lubricant to sealed or lifetime-lubricated bearings unless the manufacturer explicitly requires it.
Contact EUROTECH with your workpiece details, gripping layout, required vacuum, cycle time and operating environment. This information helps assess suitable vacuum components and the blower operating point for your handling system.
Vacuum Blower FAQs
What is a vacuum blower used for in material handling?
A vacuum blower removes air from a handling system to create a pressure difference at the gripping surface. It can be considered where porous workpieces or imperfect seals cause continuing leakage. Suitability depends on the airflow available at the required operating vacuum.
What is the difference between a vacuum pump and a vacuum blower?
The terms describe different equipment designs, not a universal pressure boundary. Compare the actual airflow and vacuum curves, allowable duty, temperature limits and power requirements. A higher maximum vacuum rating alone does not show whether a source can compensate for leakage in your application.
How do single-stage and two-stage vacuum blowers differ?
Within a comparable product family, a two-stage design may provide a greater pressure difference. The result depends on the model and operating conditions. Check the performance curve and configuration rather than assuming that every two-stage unit has the same construction or offers more airflow.
What information is needed to select a vacuum blower?
Provide the workpiece material, surface condition, gripping arrangement, leakage estimate, required vacuum, cycle time and operating hours. Also specify the available electrical supply and installation environment. These details help identify an appropriate operating point and the required filters, valves and protective devices.
What maintenance does a vacuum blower require?
Follow the manufacturer's maintenance schedule. Inspect filters, cooling passages, connections and protective devices, and investigate unusual noise, vibration or heat. Lubricate only where the manual requires it; sealed or lifetime-lubricated bearings should not receive routine lubrication unless specifically instructed.